Cisco ASA Static NAT Configuration

[lagapidis (Lazarus Agapidis)]

Hello Bruno

Take a look at this post:

Cisco ASA Dynamic NAT with DMZ

Hello Bruno The object network PUBLIC_POOL command is used to define the range of outside IP addresses to be used for NAT. This doesn’t have to be the actual physical address on the outside interface, and actually must be a range of addresses since we are configuring dynamic NAT. Actually, the IP addresses specified here don’t even have to be in the same subnet as the address of the outside interface, as long as there is routing to the configured outside NAT interfaces to reach them. I’m n…

I hope this has been helpful!

Laz