# Cisco ASA Static NAT Configuration

**URL:** <https://forum.networklessons.com/t/cisco-asa-static-nat-configuration/817>\
**Category:** Lessons Discussion\
**Created:** [December 19, 2016, 4:09pm UTC](https://forum.networklessons.com/t/cisco-asa-static-nat-configuration/817 "2016-12-19T16:09:26Z")\
**Posts on this page:** 1\
**Showing post:** 6

<div class="post-metadata">

**Author:** ![abdullimran](https://cdn-forum.networklessons.com/letter_avatar_proxy/v4/letter/a/b4bc9f/32.png) [@abdullimran](https://forum.networklessons.com/u/abdullimran)\
**Post date:** [April 9, 2016, 2:45pm UTC](https://forum.networklessons.com/t/cisco-asa-static-nat-configuration/817/6 "2016-04-09T14:45:01Z")

</div>

hi Rene Thanks for the reply  
i got most of it ,Actually my confusion started by reading the following configuration from cisco. For last if you can explain short and simple on waht is REAL\_ifc and MAPPED\_ifc from the below example this will make it crystal clear

Thanks in Advance  
nat **(real\_ifc,mapped\_ifc) dynamic mapped\_obj [interface] [dns]**

 

**Example:  
hostname (config-network-object)# nat (inside,outside) dynamic MAPPED\_IPS interface  
Configures dynamic NAT for the object IP addresses. See the following guidelines:**

 

**\*\*\*Interfaces —If you do not specify the real and mapped interfaces, all interfaces are used. You can also specify the keyword any for one or both of the interfac**

---

_[View the full topic](https://forum.networklessons.com/t/cisco-asa-static-nat-configuration/817)._