# DMVPN Phase 3 EIGRP Routing **URL:** \ **Category:** Lessons Discussion\ **Created:** [December 29, 2016, 8:30pm UTC](https://forum.networklessons.com/t/dmvpn-phase-3-eigrp-routing/1313 "2016-12-29T20:30:48Z")\ **Posts on this page:** 1\ **Showing post:** 6
**Author:** ![sdmann22](https://cdn-forum.networklessons.com/letter_avatar_proxy/v4/letter/s/50afbb/32.png) [@sdmann22](https://forum.networklessons.com/u/sdmann22)\ **Post date:** [May 16, 2016, 3:23am UTC](https://forum.networklessons.com/t/dmvpn-phase-3-eigrp-routing/1313/6 "2016-05-16T03:23:58Z")
I’m using the IOS image you said you were but for some reason when i try show ip route nhrp it doesn’t recognize “nhrp” ```auto R2#sho ip route nhrp Translating "nhrp" ^ % Invalid input detected at '^' marker. ``` Also my dmvpn table looks a bit different but still says two entries only displays one line for them ```auto R2#show dmvpn Legend: Attrb --> S - Static, D - Dynamic, I - Incompletea N - NATed, L - Local, X - No Socket # Ent --> Number of NHRP entries with same NBMA peer Tunnel0, Type:Spoke, NHRP Peers:2, # Ent Peer NBMA Addr Peer Tunnel Add State UpDn Tm Attrb ----- --------------- --------------- ----- -------- ----- 2 192.168.123.3 172.16.123.3 UP never D 1 192.168.123.1 172.16.123.1 UP 03:26:19 S ``` Last my route table doesn’t show the “%” and “H” indicators next to the routes when I configure as you did in your video. Here is my image: ROM: 3700 Software (C3725-ADVENTERPRISEK9-M), Version 12.4(15)T7, RELEASE SOFTWARE (fc3) --- _[View the full topic](https://forum.networklessons.com/t/dmvpn-phase-3-eigrp-routing/1313)._