Hi Rene,
I tried to simulate the Embedded-RP but it didn’t work.
The only stuff that worked was statically configured ipv6 pim rp-address on all the nodes.
But i was trying to check that cool feature and what i saw is that on DR (where source is connected) there’s a constant Registering appears there and RP node itself is not seeing (S,G), only (*,G) as a part of connected receiver via MLD join-group.
I don’t get what i’m missing here…
I will be very thankful to you if you can reply with your suggestions what could be the problem?
By the way does this feature supported on CSR1k, IOS-XRv and vIOS?
I tested it with CSR1k nodes
Also please tell me what does the configuration means: R1(config-subif)#ipv6 pim non-dr-join —> When should i use it?
In addition, i saw that you used loopback address with /64 and this is reflected in MCAST group with 40.
But if i will use loopback address with /128, does it mean that i will have to change 40 to 80 in MCAST group IPv6 address i will still use 40 as it’s an RFC format?
Thanks,
Regards,
Vladimir