# IPv6 RA Guard

**URL:** <https://forum.networklessons.com/t/ipv6-ra-guard/3164>\
**Category:** Lessons Discussion\
**Created:** [March 13, 2018, 2:54pm UTC](https://forum.networklessons.com/t/ipv6-ra-guard/3164 "2018-03-13T14:54:41Z")\
**Posts on this page:** 1\
**Showing post:** 4

<div class="post-metadata">

**Author:** ![andy1](https://cdn-forum.networklessons.com/letter_avatar_proxy/v4/letter/a/a8b319/32.png) [@andy1](https://forum.networklessons.com/u/andy1)\
**Post date:** [May 26, 2021, 6:49pm UTC](https://forum.networklessons.com/t/ipv6-ra-guard/3164/4 "2021-05-26T18:49:19Z")

</div>

Hi, so I’m trying to understand whats going on with this so I’ve created the test setup int CML2 and looking at the commands should the command be  
`show ipv6 route nd` instead of  
`show ipv6 route static` ?  
as when I type in show ipv6 route static I don’t see any entries  
but if I type in

```
H1#sh ipv6 route nd
    IPv6 Routing Table - default - 6 entries
    Codes: C - Connected, L - Local, S - Static, U - Per-user Static route
           B - BGP, HA - Home Agent, MR - Mobile Router, R - RIP
           H - NHRP, I1 - ISIS L1, I2 - ISIS L2, IA - ISIS interarea
           IS - ISIS summary, D - EIGRP, EX - EIGRP external, NM - NEMO
           ND - ND Default, NDp - ND Prefix, DCE - Destination, NDr - Redirect
           RL - RPL, O - OSPF Intra, OI - OSPF Inter, OE1 - OSPF ext 1
           OE2 - OSPF ext 2, ON1 - OSPF NSSA ext 1, ON2 - OSPF NSSA ext 2
           la - LISP alt, lr - LISP site-registrations, ld - LISP dyn-eid
           lA - LISP away, a - Application
    ND ::/0 [2/0]
         via FE80::5054:FF:FE10:83BD, GigabitEthernet0/1
    NDp 2001:DB8:0:1::/64 [2/0]
         via GigabitEthernet0/1, directly connected
    NDp 2001:DB8:BAD:BAD::/64 [2/0]
         via GigabitEthernet0/1, directly connected
    H1#

```

Andy

---

_[View the full topic](https://forum.networklessons.com/t/ipv6-ra-guard/3164)._