# NTP based DOS attacks

**URL:** <https://forum.networklessons.com/t/ntp-based-dos-attacks/4534>\
**Category:** Network Services\
**Created:** [August 6, 2018, 11:17am UTC](https://forum.networklessons.com/t/ntp-based-dos-attacks/4534 "2018-08-06T11:17:52Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![vlagrott](https://cdn-forum.networklessons.com/letter_avatar_proxy/v4/letter/v/82dd89/32.png) [@vlagrott](https://forum.networklessons.com/u/vlagrott)\
**Post date:** [August 6, 2018, 11:17am UTC](https://forum.networklessons.com/t/ntp-based-dos-attacks/4534/1 "2018-08-06T11:17:52Z")

</div>

Hi,

I have a 3560CX switch running the latest firmware. Prior to the latest, the switch ran into a vulnerability where it says NTP Mode Control 6 (It’s set my default) need to be changed to ‘no ntp allow mode control’. I am not sure how long ago on the firmware it required me to do that. Now I need to enforce a 3-second rate control mechanism to protect the switch from NTP based DOS attacks. Do I just enter ‘ntp allow mode control 3’? Is that now the default for the latest firmware? Thank you, Vincent

---

<div class="post-metadata">

**Author:** ![ReneMolenaar](https://cdn-forum.networklessons.com/user_avatar/forum.networklessons.com/renemolenaar/32/488_2.png) [@ReneMolenaar](https://forum.networklessons.com/u/ReneMolenaar)\
**Post date:** [August 15, 2018, 11:23am UTC](https://forum.networklessons.com/t/ntp-based-dos-attacks/4534/2 "2018-08-15T11:23:43Z")

</div>

Hi Vincent,

I checked a 3850 switch running an image from February 2018 and the default seems to be 3 seconds:

```
SW5#show version | include Version
Cisco IOS Software [Denali], Catalyst L3 Switch Software (CAT3K_CAA-UNIVERSALK9-M), Version 16.3.6, RELEASE SOFTWARE (fc3)
```

You should use `ntp mode control` btw, that’s how you rate-limit NTP. If you use `no ntp allow mode control` then you disable rate-limiting.

Rene
