OSPF Router ID

Hi willam,
Same thing I am getting in my lab devices when I am trying to change the RID based on automatically thumbrule of RID selection which Rene mentioned in lesson,

Highest IP address on a non-loopback interface.
Non loopback means physical interface

Why it’s not effecting in OSPF database?
I tried with ip OSPF process and ip OSPF process id process but same result,it’s effecting when I am trying to do follow below mention 3 steps,
1.when I rebooting the Router .
Or
2.when i remove the ip address from the interface (which is stored in OSPF database) then the valid RID is coming in OSPF database.
Or
3. when I removing the OSPF configuration (router OSPF 1) .
So I think you already replied previously but not getting clearly so can you plz explain me in detail?
I wiil wait for your reply… Today I did spend 2 hrs in my lab to find out the cause but didn’t get…I tried with lab devices(Cisco 7201,MPC480,Cisco 3560) and GNS3 as well but same result.

Rene,
I asked to you same thing in OSPF configuration lesson I shred with lot of outputs then I see in forum another one person probably asked same thing and William replied him…
So please share the exact reason really I am very excited to know this.

Thanks & Regards,
Arindom
India