Hi Andrew,
sorry wrongly i typed “Hi William,”
So Andrew Same thing I am getting in my lab devices when I am trying to change the RID based on automatically thumbrule of RID selection which Rene mentioned in lesson,
Highest IP address on a non-loopback interface.
Non loopback means physical interface
Why it’s not effecting in OSPF database?
I tried with ip OSPF process and ip OSPF process id process but same result,it’s effecting when I am trying to do follow below mention 3 steps,
1.when I rebooting the Router .
Or
2. when I removing the OSPF configuration (no router OSPF 1)
Or
3.when i remove the ip address from the interface (which is stored in OSPF database) then the valid RID is coming in OSPF database.
So I think you already replied previously but not getting clearly so can you plz explain me in detail?
I wiil wait for your reply… Yesterday I did spend 2 hrs in my lab to find out the cause but didn’t get…I tried with lab devices(Cisco 7201,MPC480,Cisco 3560) and GNS3 as well but same result.
Thanks & Regards,
Arindom
India