# OSPFv3 Authentication and Encryption

**URL:** <https://forum.networklessons.com/t/ospfv3-authentication-and-encryption/1263>\
**Category:** Lessons Discussion\
**Created:** [December 29, 2016, 7:47pm UTC](https://forum.networklessons.com/t/ospfv3-authentication-and-encryption/1263 "2016-12-29T19:47:53Z")\
**Posts on this page:** 1\
**Showing post:** 6

<div class="post-metadata">

**Author:** ![samer.rafid](https://cdn-forum.networklessons.com/letter_avatar_proxy/v4/letter/s/a4c791/32.png) [@samer.rafid](https://forum.networklessons.com/u/samer.rafid)\
**Post date:** [August 6, 2018, 1:00pm UTC](https://forum.networklessons.com/t/ospfv3-authentication-and-encryption/1263/6 "2018-08-06T13:00:26Z")

</div>

Hi,  
does this means IPsec is the only way to authenticate in OSPFv3?  
I tried with the following and it worked:

```
R2#interface Ethernet0/0

no ip address

ipv6 address 2001::2/64

ospfv3 1 authentication key-chain CISCO

ospfv3 1 ipv6 area 0

R2#show ospfv3 ipv6

OSPFv3 1 address-family ipv6

Router ID 2.2.2.2

Active Key-chains:

  Key chain CISCO: Send key 1, Algorithm HMAC-SHA-1, Number of interfaces 1

    Area BACKBONE(0)

```

thanks

Edit: This post gives the idea that OSPFv3 does not support any authentication beside IPsec, but after checking it does support the usual MD5 and HMAC that I mentioned above.  
Samer.

---

_[View the full topic](https://forum.networklessons.com/t/ospfv3-authentication-and-encryption/1263)._
