Why do we need QoS on LAN Switches

This topic is to discuss the following lesson:

Hi Rene,
Could you please do a short demo?
I have 1x3560 and 2x3550, i have configured QoS (similar to the first topology) but i think it is not working well.
Br,
István

Hi István,

What would you like to see? We can do classification, marking, queuing, shaping and policing on the switches :slight_smile:

Rene

Hi Rene,

Do we have qos of service on LAN switches only?. Why not on a WAN and Router as well?.
If we can have the same on Router, is it the same procedure as well as well.
Thanks,
peter

Hi Peter,

QoS is applied everywhere, switches and routers. The configuration on routers is very different however…

Rene

Hi Rene/Andrew

Can you help me in understanding AutoQoS concept please ?

Thanks

Hi Abhishek,

Let me jump in to give you a brief explanation of Cisco AutoQos.

Configuring QOS can be a challenge for engineers who aren’t familiar with this topic, but leaving the network without a QOS configuration can cause a lot troubles especially with the bandwidth-hungry applications and the real-time traffic such as VOIP and Video which can partially and/or fully not work if QOS isn’t configured, in addition of problems like latency, jitter, and packet drops.

For this reason, Cisco IOS Software offers a portfolio of QoS features which is enable by a or few commands without an extensive knowledge needed from the IT administrator and it provide the essential QOS needed.

If you want to know more of AutoQOS, I can refer you to this article from Cisco Wesbite.

Thankyou Maher, That helps !

Hi Rene
In a access ,distribution and core architecture where we should do the qos

Thanks

Hello Sims

This is a very good question that doesn’t have a clear cut answer.

In the hierarchical model, the core is performing high speed routing and switching to get things from place to place, the distribution layer is applying policies and filtering, and the access layer is providing you with port density and user connectivity. Based on this, and based on most textbooks and CCNP study material, QoS is said to be most commonly applied at the distribution layer.

However, Layer 2 switches at the access layer can perform both marking and queuing and in general it is good design to apply QoS as close to the equipment or services for which you need to guarantee network resources as possible. In a live network that may very well be in the access layer on your switches, or even at the phone port.

I hope this has been helpful!

Laz