Cisco ASA Anyconnect Remote Access VPN LESSON

I have a 5505 in my lab. I was following the lesson above when I came to the section to configure the tunnel group looks like the type command is not supported. Do I need to use a 5510 for this configuration. Thanks

ASA1(config)# tunnel-group MY_TUNNEL type remote-access 
ASA1(config)# tunnel-group MY_TUNNEL general-attributes 
ASA1(config-tunnel-general)# default-group-policy ANYCONNECT_POLICY
ASA1(config-tunnel-general)# address-pool VPN_POOL
ASA1(config-tunnel-general)# exit

A post was merged into an existing topic: Cisco ASA Anyconnect Remote Access VPN