Configure Wired 802.1x with NPS and Cisco Switch

Routing & Switching Security
1

Dear Sir,
I am beginner in networking. i would like to ask about 802.1x authenication . i try to configure 802.1x Configure Wired 802.1X with NPS without using ISE or third-party appliance. i followed these tutorials. but i got authentication fails errors.
if i got the permit to upload ,i can upload my configuration notes.

https://networklessons.com/uncategorized/peap-and-eap-tls-on-server-2008-and-cisco-wlc/[Other Sites Links](https://community.spiceworks.com/topic/2120840-wired-802-1x-nps-and-certificates .)

2

Hello Ko

Can you share with us what you have done and what kinds of errors you see? No need to share the whole config yet, just give a short explanation of what you’ve done and at what point you see errors and what those are.

Looking forward to helping you out.

Laz

1 Like