Hi William,
Under topology base you will find commands that have to do with the EIGRP topology table. Stuff like redistribution, filtering, etc. Here’s an overview of all commands:
R1(config-router)#router eigrp TEST
R1(config-router)#address-family ipv4 unicast autonomous-system 1
R1(config-router-af)#topology base
R1(config-router-af-topology)#?
Address Family Topology configuration commands:
auto-summary Enable automatic network number summarization
cts EIGRP Trustsec Configuration
default Set a command to its defaults
default-information Control distribution of default information
default-metric Set metric of redistributed routes
distance Define an administrative distance
distribute-list Filter entries in eigrp updates
eigrp EIGRP specific commands
exit-af-topology Exit from Address Family Topology configuration mode
maximum-paths Forward packets over multiple paths
metric Modify metrics and parameters for advertisement
no Negate a command or set its defaults
offset-list Add or subtract offset from EIGRP metrics
redistribute Redistribute IPv4 routes from another routing protocol
snmp Modify snmp parameters
summary-metric Specify summary to apply metric/filtering
timers Adjust topology specific timers
topo-interface Enter Topology interface configuration
traffic-share How to compute traffic share over alternate paths
variance Control load balancing variance
Rene