Hi there ! I am from canada


(Tejpal G) #1

Hello Rene,

This is my first post and hope i am posting it in a right way.
Want to know as per the topology for dynamic NAT, when we convert router to HOST 2 by using the command no ip routing, i am able to piing the 192.168.23.3 IP address without any issues.
but if i do not convert the router to HOST and keep the router with routing enable with the command IP routing, i am not able to ping the 192.168.23.3 this might be because there is no route in HOST2 to reach the router Web1, then why when we configure no IP routing on HOST2 we are able to ping the router WEB1 ip address even though no default gateway is configured on HOST2.


(Rene Molenaar) #2

A post was merged into an existing topic: Cisco ASA Dynamic NAT Configuration


(Rene Molenaar) #3