Ip nat outside command not available

Routing & Switching Network Services
1

Hello there,

just joined the community and already struggling with a lesson :slight_smile:
I cannot configure ip nat commands on a physical interface of a C3560 multilayer switch. I can configure it on a vlan interface but not e.g. on Gi0/1. The CLI just don´t recognize the ip nat inside command.
The lab is running in Packet Tracer 7.2.2.0418. Is that a limitation of the switch or the virtual environment?

2

A post was merged into an existing topic: How to configure Static NAT on Cisco IOS Router